Option Troubles
When option-related troubles occur, refer to the table below to address them.
| Symptom | Phenomenon image | Confirmation and action | Floor Finisher | Saddle Unit | Inner Finisher | High Capacity Unit |
|---|---|---|---|---|---|---|
| Misalignment | - | Make the following adjustments sequentially. Floor Finisher Saddle Unit Inner Finisher |
Yes | Yes | Yes | |
| Paper Edge Misalignment (Misalignment of stairs states) |
|
Paper Edge Misalignment (Misalignment of stairs states) | Yes | |||
| Paper Edge Misalignment (Irregular Misalignment) |
|
Paper Edge Misalignment (Irregular Misalignment) | Yes | |||
Alignment failure of the Wait Drum (Paper is misaligned horizontally) |
- | Make the following adjustments sequentially. |
Yes | |||
Paper ejection position is incorrect (Finisher binding processing is inaccurate in positioning) |
- | Make the following adjustments sequentially. |
Yes | |||
Stapling position is incorrect |
- | Make the following adjustments sequentially. Floor Finisher Saddle Unit Inner Finisher |
Yes | Yes | Yes | |
| Punch misalignment (The punched holes are slanted because the paper was skewed) |
- | Make the following adjustments sequentially. Floor Finisher Inner Finisher |
Yes | Yes | ||
Punching position is incorrect (The distance from the edge of the paper to the hole is incorrect) (The holes are positioned differently on the left and right sides) |
- | Make the following adjustments sequentially. Floor Punch
Inner Punch |
Yes | Yes | ||
| Saddle Stitch Misalignment | - | Make the following adjustments. |
Yes | |||
| Saddle stitching folding position shift | - | Make the following adjustments. |
Yes | |||
| Printing position shifted in the paper width direction | - | Make the following adjustments. |
Yes | |||
| Staple cartridge not recognized | - | Check the following.
If the problem persists after checking the above, take the following steps in order.
|
○ |
