FIN Pulling Paddle Release Motor Jam
Error code
- 133 Pulling Paddle Release Motor Jam
Occurrence condition
- Even if IN FIN Pulling Paddle Release Drive Motor is driven in the HP sensor change direction for 3 seconds, IN FIN Pulling Paddle Release HP Sensor change is not detected.
Assumed cause
- IN FIN Paper Pulling Paddle dirty, deformed, or not fitted properly
- IN FIN Pulling Paddle Release HP Sensor dirty, missing or defective
- IN FIN Pulling Paddle Release Drive Motor dirty, missing or defective
- Inner finisher main board failure
Related parts
- IN FIN Pulling Paddle
- IN FIN Pulling Paddle Release HP Sensor
- IN FIN Pulling Paddle Release Drive Motor
- Inner finisher main board
Troubleshooting
Step |
Confirmation and action |
YES |
NO |
|---|---|---|---|
| 1 | Checking IN FIN Pulling Paddle Is the IN FIN Pulling Paddle installed properly? Or is it dirty, deformed or worn? |
Clean IN FIN Pulling Paddle Replace if not repaired |
Go to step 2 |
| 2 | IN FIN Pulling Paddle Release HP SensorCheck the connection of the connector Are the IN FIN Pulling Paddle Release HP Sensor connected properly? |
Go to step 3 | reconnect IN FIN Pulling Paddle Release HP Sensor |
| 3 | IN FIN Pulling Paddle Release HP SensorOperation Check Is the IN FIN Pulling Paddle Release HP Sensor operating normally in the diagnostics menu? |
Go to step 4 | Replace IN FIN Pulling Paddle Release HP Sensor |
| 4 | IN FIN Pulling Paddle Release Drive MotorCheck the connection of the connector Are the IN FIN Pulling Paddle Release Drive Motor connected properly? |
Go to step 5 | reconnect IN FIN Pulling Paddle Release Drive Motor |
| 5 | IN FIN Pulling Paddle Release Drive MotorOperation Check Is the IN FIN Pulling Paddle Release Drive Motor operating normally in the diagnostics menu? |
Go to step 6 | Replace IN FIN Pulling Paddle Release Drive Motor |
| 6 | Replacing the inner finisher main board Have you reconnected and repaired the connector on the inner finisher main board? |
End | Replace Inner finisher main board |