2050107 Punch Stack (Other than 2 holes)

Perform punching of holes other than 2 holes (3/4 holes) and discharge the paper. The number of holes depends on the type of Punch Unit installed.

  1. Start the service support mode.
  2. Select [02 Check Pattern Print / Paper Feed Confirmation].
  3. Select [Finisher] tab.
  4. Select [2050107 Punch Stack (Other than 2 holes)].
  5. Press each setting item button to make the print settings.


    The parameters that can be set are as follows.

    Setting Items

    Selection
    Feed Tray C1, C2, C3, C4, Paper Tray
    Available Paper Sizes A4 (Vertical), Letter (Vertical), A3, Ledger
    Number of Feed 1 - 100 sheets
    Check Point / チェックポイント

    Up to 30 sheets of A3 size paper can be fed. Even entering 30 or more for the number of feed, only 30 sheets are fed.
    Caution / 注意

    Make sure the paper orientation is as specified (LEF/Vertical).

    If the orientation is different from the specifications (SEF/Horizontal), the paper will be ejected without being processed correctly and the operation cannot be checked.
  6. Press [Execution] after completing the settings.