FIN Rear-edge Tapping Motor error

Error code

035042 FIN Rear-edge Tapping Motor error

Occurrence condition

Even if the FIN Rear-edge Tapping Motor is driven in the direction of HP sensor fluctuation for 3s, the change of the FIN Rear-edge Tapping Sensor is not detected.

Assumed cause

FIN Rear-edge Tapping Unit dirty, missing or defective
FIN Rear-edge Tapping Motor dirty, missing or defective
FIN Rear-edge Tapping Sensor dirty, missing or defective
Floor Finisher main board failure

Related parts

FIN Rear-edge Tapping Unit Drive Parts
FIN Rear-edge Tapping Motor
FIN Rear-edge Tapping Sensor
Floor Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Check FIN Rear-edge Tapping Unit Drive Parts Is the FIN Rear-edge Tapping Unit Drive Parts installed properly? Are there any problems with the drive parts?	Go to step 2	Reinstall FIN Rear-edge Tapping Unit Drive Parts Replace if not repaired
2	Check the FIN Rear-edge Tapping Motor [Part(s) to be checked] FIN Rear-edge Tapping Motor - Floor Finisher Main Board [Confirmation details] Is the FIN Rear-edge Tapping Motor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Rear-edge Tapping Motor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 3	In case of falling off or improper installation Reassembly of the FIN Rear-edge Tapping Motor If there is an abnormality (damage/wear) Replace FIN Rear-edge Tapping Motor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
3	Check the operation of the FIN Rear-edge Tapping Motor Are the following motors operating normally in Failure Verification menu? FIN Rear-edge Tapping Motor	Go to step 4	Replace FIN Rear-edge Tapping Motor
4	Check the FIN Rear-edge Tapping Sensor [Part(s) to be checked] FIN Rear-edge Tapping Sensor - Floor Finisher Main Board [Confirmation details] Is the FIN Rear-edge Tapping Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Rear-edge Tapping Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 5	In case of falling off or improper installation Reassembly of the FIN Rear-edge Tapping Sensor If there is an abnormality (damage/wear) Replace the FIN Rear-edge Tapping Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
5	Check the operation of the FIN Rear-edge Tapping Sensor Are the following sensor operating normally in Failure Verification menu? FIN Rear-edge Tapping Sensor	Go to step 6	Replace the corresponding sensor
6	Replacing floor finisher main board Replaced the floor finisher main board, did the phenomenon improve?	End	Contact Epson local service representatives.