FIN Processing Jam (Feed delay)
Error code
- 106 FIN Processing Jam (Feed delay)
Occurrence condition
- FIN Finisher Tray Ejection Sensor does not turn ON even after the specified time has passed since the FIN Finisher Tray Ejection Sensor turned ON.
Assumed cause
- Rollers, guides, etc. are dirty, deformed, or not installed properly
- FIN Output Tray Lower Eject Sensor dirty, missing or defective
- FIN Paper Eject clutch dirty, missing or defective
- FIN Paper Eject Motor dirty, missing or defective
- FIN Middle Roller Drive Motor dirty, missing or defective
- Floor Finisher main board failure
Related parts
- FIN Finisher Tray Ejection Sensor
- FIN Ejection Clutch
- FIN Paper Eject Motor
- FIN Mid Drive Motor
- Floor Finisher main board failure
Troubleshooting
Step |
Confirmation and action |
YES |
NO |
|---|---|---|---|
| 1 | Check the Paper transport parts Is the Paper transport parts installed properly? Are the paper transport parts dirty or deformed? |
Reinstall the paper transport assembly Replace if not repaired |
Go to step 2 |
| 2 | FIN Lower Tray Ejection Sensor connector connection check Are the FIN Lower Tray Ejection Sensor connected properly? |
Go to step 3 | Reconnect FIN Lower Tray Ejection Sensor |
| 3 | Operation check of FIN Lower Tray Ejection Sensor Is the FIN Finisher Tray Ejection Sensor operating normally in the diagnostics menu? |
Go to step 4 | Replace FIN Finisher Tray Ejection Sensor |
| 4 | FIN Ejection Clutch connector connection check Are the FIN Paper Eject clutch connected properly? |
Go to step 5 | Reconnect FIN Paper Eject clutch |
| 5 | Replacing the FIN Paper Eject clutch |
Replace the FIN Paper Eject clutch and go to step 6 |
|
| 6 | FIN Paper Eject Motor connector connection check Are the Paper Eject Motor connected properly? |
Go to step 7 | Reconnect FIN Paper Eject Motor |
| 7 | Operation check of FIN Paper Eject Motor Is the FIN Paper Eject Motor operating normally in the diagnostics menu? |
Go to step 8 | Replace FIN Paper Eject Motor |
| 8 | Confirmation of FIN Mid Drive Motor connector connection Are the FIN Mid Drive Motor connected properly? |
Go to step 9 | Reconnect FIN Mid Drive Motor |
| 9 | Operation check of FIN Mid Drive Motor Is the FIN Mid Drive Motor operating normally in the diagnostics menu? |
Go to step 10 | Replace FIN Mid Drive Motor |
| 10 | Replacing floor finisher main board Have you reconnected and repaired the connector on the floor finisher main board? |
End | Replace floor finisher main board |