Wiper Ink collector Assy

  1. Remove the 4 screws and remove the right cover sub (A).
    • : 3x10DW
  2. Remove 1 screw and slide the rear cover (A) in the direction of the arrow to remove it.
    • : 3x10DW
    Assembly / 組み立て

    Align the 5 hooks on the rear cover with the 5 holes on the main unit and attach it.
  3. Remove 2 screws and remove the Wiper Ink Collector Assy (A).

    • :3x5D/TBD

    Caution / 注意
    • When the wiper ink collection assembly is removed, it must be placed in a zipped plastic bag (A) because ink may drip from the wiper ink collection assembly.
    • Waste ink may accumulate inside the Wiper Ink Collector Assy (The whole wall and the circled areas in the figure below). Wipe up if necessary.
    • Insert the protrusion of the Wiper Ink Collector Assy into the opening (A) of the frame, and fix it so that the waste ink absorption needle faces upward.
    Assembly / 組み立て
    • To prevent damage to the Wiper Ink Collector Assy, it is necessary to assemble with Wiper Assy (A) moved to the far side (inside the product). Rotate the wiper drive gear shown in the figure below anticlockwise until the wiper stops moving.