Paper Holding Unit

  1. Refer to the following and remove the floor finisher from the printer main unit.
    Floor Finisher Installation Procedure
    Caution / 注意
    • When disconnecting the Floor Finisher from the Main Unit, the power of the Main Unit must be turned off.

  2. Remove 1 screw of the Rear Cover, Sub (A).

  3. Put your finger on the recess of the rear cover, sub (A) and open it to the left to remove it.


    • : 4x10DC

  4. Remove 3 screws of the Rear Cover, Upper (A).

  5. Slightly raise the top cover (B) and remove the rear cover, upper (A).


    • : 4x10DC
  6. Remove 2 screws and remove the Rear Cover, Lower (A).
    • : 4x10DC
  7. Release the tabs (x2) and remove the Lower Tray (A) upwards.
  8. Rotate the gear (A) of the Tray Lifting Gear Block counterclockwise using a screwdriver (B) or the like to lower the tray mounting frame (C).
  9. Remove the 6 screws and remove the part (A) of the tray mounting frame.

    • : 4x10DC
  10. Retract the tray mounting frame (A) to the front side and rear side respectively.
  11. Remove the 6 screws that secure the Left Side Lift Guide Cover (A).
  12. With the tray mounting frame (B) lowered to bottom, slide the Left Side Lift Guide Cover (A) upward and remove it.

    • : 3x8 DC/P

  13. Remove the cables (x2) (A) from the connectors.
  14. Remove the one screw.
  15. Slide the metal plate (C) connecting the lower unit (A) and paper holding unit (B).

    • : 3x8D/P
  16. Remove 5 screws.
    • : 3x8D/P
    • : 4x8D/P
  17. Remove the paper holding unit (A).