IN FIN Pulling Paddle Motor error

Error code

035400 IN FIN Pulling Paddle Motor error

Occurrence condition

00132 FIN Pulling Guide Motor Jam (Inner finisher) is detected twice in succession

Assumed cause

IN FIN Pulling Paddle Drive Parts dirty, deformed, or not fitted properly
IN FIN Paper Pulling Paddle HP Sensor dirty, missing or defective
IN FIN Pulling Paddle Motor dirty, missing or defective
Inner Finisher main board failure

Related parts

IN FIN Pulling Paddle Drive Parts
IN FIN Paper Pulling Paddle HP Sensor
IN FIN Pulling Paddle Motor
Inner Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Check the IN FIN pulling paddle drive parts Is the IN FIN Pulling Paddle drive parts installed properly? Are there any problems with the drive parts?	Go to step 2	Reinstall the IN FIN pulling paddle drive parts Replace if not repaired
2	Check the IN FIN Pulling Paddle Motor [Part(s) to be checked] IN FIN Pulling Paddle Motor - Inner Finisher Main Board [Confirmation details] Is the IN FIN Pulling Paddle Motor missing or improperly installed? Is there any abnormality (damage/wear) in the IN FIN Pulling Paddle Motor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 3	In case of falling off or improper installation Reassembly of the IN FIN Pulling Paddle Motor If there is an abnormality (damage/wear) Replace the IN FIN Pulling Paddle Motor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
3	Check the operation of the IN FIN Pulling Paddle Motor Are the following motors operating normally in Failure Verification menu? IN FIN Pulling Paddle Motor	Go to step 4	Replace the IN FIN Pulling Paddle Motor
4	Check the IN FIN Paper Pulling Paddle HP Sensor [Part(s) to be checked] IN FIN Paper Pulling Paddle HP Sensor - Inner Finisher Main Board [Confirmation details] Is the IN FIN Paper Pulling Paddle HP Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the IN FIN Paper Pulling Paddle HP Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 5	In case of falling off or improper installation Reassembly of the IN FIN Paper Pulling Paddle HP Sensor If there is an abnormality (damage/wear) Replace IN FIN Paper Pulling Paddle HP Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
5	Check the IN FIN Paper Pulling Paddle HP Sensor operation Are the following sensor operating normally in Failure Verification menu? IN FIN Paper Pulling Paddle HP Sensor	Go to step 6	Replace the corresponding sensor
6	Replacing the inner finisher main board Replaced the inner finisher main board and did the problem improve?	End	Contact Epson local service representatives.