IN FIN Pulling Paddle Release Drive Motor error

Error code

035415 IN FIN Pulling Paddle Release Drive Motor error

Occurrence condition

When the 00132 FIN Pulling Paddle Release Motor Jam is detected twice consecutively

Assumed cause

Deformation, dropout, or failure of IN FIN Pulling Paddle drive parts
IN FIN Pulling Paddle Release Drive Motor dirty, missing or defective
IN FIN Pulling Paddle Release HP Sensor dirty, missing or defective
Inner Finisher main board failure

Related parts

IN FIN pulling paddle drive parts
IN FIN Pulling Paddle Release Drive Motor
IN FIN Pulling Paddle Release HP Sensor
Inner Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Check the IN FIN pulling paddle drive parts Is the IN FIN Pulling Paddle drive parts installed properly? Are there any problems with the drive parts?	Go to step 2	Reinstall the IN FIN pulling paddle drive parts Replace if not repaired
2	Check the IN FIN Pulling Paddle Release Drive Motor [Part(s) to be checked] IN FIN Pulling Paddle Release Drive Motor - Inner Finisher Main Board [Confirmation details] Is the IN FIN Pulling Paddle Release Drive Motor missing or improperly installed? Is there any abnormality (damage/wear) in the IN FIN Pulling Paddle Release Drive Motor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 3	In case of falling off or improper installation Reassembly of the IN FIN Pulling Paddle Release Drive Motor If there is an abnormality (damage/wear) Replace the IN FIN Pulling Paddle Release Drive Motor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
3	Check the IN FIN Pulling Paddle Release Drive Motor operation Are the following motors operating normally in Failure Verification menu? IN FIN Pulling Paddle Release Drive Motor	Go to step 4	Replace the IN FIN Pulling Paddle Release Drive Motor
4	Check the IN FIN Pulling Paddle Release HP Sensor [Part(s) to be checked] IN FIN Pulling Paddle Release HP Sensor - Inner Finisher Main Board [Confirmation details] Is the IN FIN Pulling Paddle Release HP Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the IN FIN Pulling Paddle Release HP Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 5	In case of falling off or improper installation Reassembly of the IN FIN Pulling Paddle Release HP Sensor If there is an abnormality (damage/wear) Replace the IN FIN Pulling Paddle Release HP Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
5	Check the IN FIN Pulling Paddle Release HP Sensor operation Are the following sensor operating normally in Failure Verification menu? IN FIN Pulling Paddle Release HP Sensor	Go to step 6	Replace the corresponding sensor
6	Replacing the inner finisher main board Replaced the inner finisher main board and did the problem improve?	End	Contact Epson local service representatives.