IN FIN Alignment Paddle error

Error code

035411 IN FIN Alignment Paddle error

Occurrence condition

00116 FIN Alignment Paddle Jam (Inner finisher) is detected twice in succession

Assumed cause

Deformation, dropout, or failure of IN FIN Alignment Paddle Drive Parts
IN FIN Middle Roller Drive Motor dirty, missing or defective
IN FIN Alignment Paddle HP Sensor dirty, missing or defective
Inner Finisher main board failure

Related parts

IN FIN Alignment Paddle Drive Parts
IN FIN Middle Roller Drive Motor
IN FIN Alignment Paddle HP Sensor
Inner Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Check the IN FIN Alignment Paddle Drive Parts Is the IN FIN Alignment Paddle Drive Parts installed properly? Are there any problems with the drive parts?	Go to step 2	Reinstall the IN FIN Alignment Paddle Drive Parts Replace if not repaired
2	Check the IN FIN Middle Roller Drive Motor [Part(s) to be checked] IN FIN Middle Roller Drive Motor - Inner Finisher Main Board [Confirmation details] Is the IN FIN Middle Roller Drive Motor missing or improperly installed? Is there any abnormality (damage/wear) in the IN FIN Middle Roller Drive Motor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 3	In case of falling off or improper installation Reassembly of the IN FIN Middle Roller Drive Motor If there is an abnormality (damage/wear) Replace the IN FIN Middle Roller Drive Motor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
3	Check the operation of the IN FIN Middle Roller Drive Motor Are the following motors operating normally in Failure Verification menu? IN FIN Middle Roller Drive Motor	Go to step 4	Replace the IN FIN Middle Roller Drive Motor
4	Check the IN FIN Alignment Paddle HP Sensor [Part(s) to be checked] IN FIN Alignment Paddle HP Sensor - Inner Finisher Main Board [Confirmation details] Is the IN FIN Alignment Paddle HP Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the IN FIN Alignment Paddle HP Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 5	In case of falling off or improper installation Reassembly of the IN FIN Alignment Paddle HP Sensor If there is an abnormality (damage/wear) Replace the IN FIN Alignment Paddle HP Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
5	Check the operation of the IN FIN Alignment Paddle HP Sensor Are the following sensor operating normally in Failure Verification menu? IN FIN Alignment Paddle HP Sensor	Go to step 6	Replace the corresponding sensor
6	Replacing the inner finisher main board Replaced the inner finisher main board and did the problem improve?	End	Contact Epson local service representatives.