FIN Width Alignment Motor error 2

Error code

035010 FIN Width Alignment Motor error 2

Occurrence condition

00113 FIN Pre-Alignment jam was detected twice in a row.

Assumed cause

Deformation, dropout, or failure of FIN Alignment Plate Front
Deformation, dropout, or failure of FIN Alignment Plate Front Drive Parts
FIN Width Adjustment Front Motor dirty, missing or defective.
FIN Alignment Plate Front HP Sensor dirty, missing or defective.
Floor Finisher main board failure

Related parts

FIN Alignment Plate Front
FIN Alignment Plate Front Drive Parts
FIN Before Width Alignment Motor
FIN Alignment Plate Front HP Sensor
Floor Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Check the FIN Alignment Plate Front Is the FIN Alignment Plate Front assembled correctly?	Go to step 2	If the FIN Alignment Plate Front cannot be moved manually, fix the part where it is stuck.
2	Check the FIN Alignment Plate Front Drive Parts Is the FIN Alignment Plate Front Drive Parts installed properly? Are there any problems with the drive parts?	Go to step 3	Reinstall the FIN Alignment Plate Front Drive Parts Replace if not repaired
3	Check the FIN Width Adjustment Motor Front [Part(s) to be checked] FIN Width Adjustment Motor Front - Floor Finisher Main Board [Confirmation details] Is the FIN Width Adjustment Motor Front missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Width Adjustment Motor Front? Are the connectors connected properly? Are there any problems with the wires?	Go to step 4	In case of falling off or improper installation Reassembly of the FIN Before Width Alignment Motor If there is an abnormality (damage/wear) Replace FIN Width Alignment Front Motor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
4	Check the operation of the FIN Before Width Alignment Motor Are the following motors operating normally in Failure Verification menu? Width Adjustment Test (A3) Width Adjustment Test (LD)	Go to step 5	Replace the FIN Before Width Alignment Motor
5	Check the FIN Alignment Plate Front HP Sensor [Part(s) to be checked] FIN Alignment Plate Front HP Sensor - Floor Finisher Main Board [Confirmation details] Is the FIN Alignment Plate Front HP Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Alignment Plate Front HP Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 6	In case of falling off or improper installation Reassembly of the FIN Alignment Plate Front HP Sensor If there is an abnormality (damage/wear) Replace the FIN Alignment Plate Front HP Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
6	Check the operation of the FIN Alignment Plate Front HP Sensor Are the following sensor operating normally in Failure Verification menu? FIN Alignment Plate Front HP Sensor	Go to step 7	Replace the corresponding sensor
7	Replacing floor finisher main board Replaced the floor finisher main board, did the phenomenon improve?	End	Contact Epson local service representatives.