FIN Pulling Guide Motor error

Error code

035041 FIN Pulling Guide Motor

Occurrence condition

Even if the FIN Pulling Guide Motor is driven for 3s, the change of the FIN Paper Pulling Paddle HP Sensor is not detected.

Assumed cause

FIN Pulling Guide Drive Parts dirty, missing or defective
FIN Pulling Guide Motor dirty, missing or defective
FIN Pulling Paddle Release HP Sensor dirty, missing or defective
Floor Finisher main board failure

Related parts

FIN Pulling Guide Drive Parts
FIN Pulling Guide Motor
FIN Paper Pulling Paddle HP Sensor
Floor Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Checking the FIN Pulling Guide Drive Parts Is the FIN Pulling Guide Drive Parts installed properly? Are there any problems with the drive parts?	Go to step 2	Reinstall the FIN Pulling Guide Drive Parts Replace if not repaired
2	Check the FIN Pulling Guide Motor [Part(s) to be checked] FIN Pulling Guide Motor - Floor Finisher Main Board [Confirmation details] Is the FIN Pulling Guide Motor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Pulling Guide Motor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 3	In case of falling off or improper installation Reassembly of the FIN Pulling Guide Motor If there is an abnormality (damage/wear) Replace the FIN Pulling Guide Motor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
3	Check the operation of the FIN Pulling Guide Motor Are the following motors operating normally in Failure Verification menu? FIN Pulling Guide Motor	Go to step 4	Replace the FIN Pulling Guide Motor
4	Check the FIN Paper Pulling Paddle HP Sensor [Part(s) to be checked] FIN Paper Pulling Paddle HP Sensor - Floor Finisher Main Board [Confirmation details] Is the FIN Paper Pulling Paddle HP Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Paper Pulling Paddle HP Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 5	In case of falling off or improper installation Reassembly of the FIN Paper Pulling Paddle HP Sensor If there is an abnormality (damage/wear) Replace the FIN Paper Pulling Paddle HP Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
5	Check the operation of the FIN Paper Pulling Paddle HP Sensor Are the following sensor operating normally in Failure Verification menu? FIN Paper Pulling Paddle HP Sensor	Go to step 6	Replace the corresponding sensor
6	Replacing floor finisher main board Replaced the floor finisher main board, did the phenomenon improve?	End	Contact Epson local service representatives.