Motor / Sensor / Solenoid

  1. Refer to the following to remove the inner punch unit from the inner finisher.
    Inner Punch Unit Installation Procedure
  2. Remove the wire stopper (A).
  3. Release the hook and remove the cable clamp (A).
  4. Remove the 2 screws.

    • : 3x8 DC/P
  5. Release the 5 hooks and remove the Punch Front Cover (A).

Motor / Solenoid
No. Name Function Type
1 IN PNC Punch Motor Used for punch operation drive. -
2 IN PNC Switch Punch Hole Solenoid Used for switching the punch hole position.
3 IN PNC Punch Waste Tray Solenoid -
Sensors
No. Name Function Type
4 IN PNC HP Sensor Used for detecting the position of a punch operation (punch cam operation). -
5 IN PNC Pulse Sensor
6 IN PNC Punch Paper Transport Sensor Used for detecting paper.
7 IN PNC Punch Waste Tray Sensor Used for detecting whether the punch waste tray is attached or not.
8 IN PNC Punch Waste Tray Full Detection Sensor -