FIN Mid Drive Motor HP Error

Error code

035017 FIN Mid Drive Motor HP Error

Occurrence condition

00116 FIN Alignment Paddle jam detected twice in a row

Assumed cause

FIN Paper Guide Drive Parts dirty, missing or defective
FIN Middle Roller Drive Motor dirty, missing or defective
FIN Alignment Paddle HP Sensor dirty, missing or defective
Floor Finisher main board failure

Related parts

FIN Paper Guide Drive Parts
FIN Mid Drive Motor
FIN Alignment Paddle HP Sensor
Floor Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Checking the FIN Paper Guide Drive Parts Is the FIN Paper Guide Drive Parts installed properly? Are there any problems with the drive parts?	Go to step 2	Reinstall the FIN Paper Guide Drive Parts Replace if not repaired
2	Checking the FIN Middle Roller Drive Motor [Part(s) to be checked] FIN Middle Roller Drive Motor - Floor Finisher Main Board [Confirmation details] Is the FIN Middle Roller Drive Motor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Middle Roller Drive Motor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 3	In case of falling off or improper installation FIN Mid Drive Motor If there is an abnormality (damage/wear) FIN Mid Drive Motor Improper connector connection If the wire is abnormal
3	Check the operation of the FIN Middle Roller Drive Motor Are the following motors operating normally in Failure Verification menu? FIN Mid Drive Motor	Go to step 4	Replace FIN Mid Drive Motor
4	FIN Alignment Paddle HP Sensor [Part(s) to be checked] FIN Alignment Paddle HP Sensor - Floor Finisher Main Board [Confirmation details] Is the FIN Alignment Paddle HP Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Alignment Paddle HP Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 5	In case of falling off or improper installation FIN Alignment Paddle HP Sensor If there is an abnormality (damage/wear) Replace FIN Alignment Paddle HP Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
5	Check the operation of the FIN Alignment Paddle HP Sensor Are the following sensor operating normally in Failure Verification menu? FIN Alignment Paddle HP Sensor	Go to step 6	Replace the corresponding sensor
6	Replacing floor finisher main board Replaced the floor finisher main board, did the phenomenon improve?	End	Contact Epson local service representatives.