SDL Stapler Drive Motor error 2

00127 SDL Stapler Jam was detected twice in a row.
(Second jam detection condition: A motor lock was detected while the SDL Stapler Drive Motor was running.)

Step	Confirmation and action	YES	NO
1	Check the SDL Stapler Unit Is the SDL Stapler Unit assembled correctly?	Go to step 2	If the SDL Stapler Unit does not work manually, fix the part where it is stuck.
2	Check the SDL Stapler Unit Drive Parts Is the SDL Stapler Unit Drive Parts installed properly? Are there any problems with the drive parts?	Go to step 3	Reinstall the SDL Stapler Unit Drive Parts Replace if not repaired
3	Check the SDL Stapler Unit [Part(s) to be checked] SDL Stapler Unit - SDL Unit Main Board [Confirmation details] Is the SDL Stapler Unit missing or not properly installed? Is there any abnormality (damage or wear) in the SDL Stapler Unit? Are the connectors connected properly? Are there any problems with the wires?	Go to step 4	In case of falling off or improper installation Reassembly of the SDL Stapler Unit If there is an abnormality (damage/wear) Replace the SDL Stapler Unit. Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
4	Check the operation of the SDL Stapler Drive Motor Are the following motors operating normally in Failure Verification menu? SDL Stapler Drive Motor	Go to step 5	Replace the SDL Stapler Unit.
7	Replace SDL Unit Main Board Replaced the SDL Unit Main Board and did the problem improve?	End	Contact Epson local service representatives.

# SDL Stapler Drive Motor error 2