FIN Shift Arm Release Motor error

Error code

035005 FIN Shift Arm Release Motor error

Occurrence condition

When the FIN shift arm release motor is driven, the FIN Shift Arm Release Position HP Sensor does not turn ON even after 1 second.

Assumed cause

Deformation, dropout, or failure of FIN Shift Arm Rear
Deformation, dropout, or failure of FIN Shift Arm Rear Drive Parts
FIN Shift Arm Release Motor dirty, missing or defective
FIN Shift Arm Release Position HP Sensor
Floor Finisher main board failure

Related parts

FIN Shift Arm Rear
FIN Shift Arm Rear Drive Parts
FIN Shift Arm Release Motor
FIN Shift Arm Release Position HP Sensor
Floor Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Check the FIN Shift Arm Rear Is the FIN Shift Arm Rear assembled correctly?	Go to step 2	If the FIN Shift Arm Rear cannot be moved manually, fix the part where it is stuck.
2	Check the FIN Shift Arm Rear Drive Parts Is the FIN Shift Arm Rear Drive Parts installed properly? Are there any problems with the drive parts?	Go to step 3	Reinstall the FIN Shift Arm Rear Drive Parts Replace if not repaired
3	Check the FIN Shift Arm Release Motor [Part(s) to be checked] FIN Shift Arm Release Motor - Floor Finisher Main Board [Confirmation details] Is the FIN Shift Arm Release Motor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Shift Arm Release Motor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 4	In case of falling off or improper installation Reassembly of the FIN Shift Arm Release Motor If there is an abnormality (damage/wear) Replace the FIN Shift Arm Release Motor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
4	Check the operation of the FIN Shift Arm Release Motor Are the following motors operating normally in Failure Verification menu? FIN Shift Arm Release Motor	Go to step 5	Replace the FIN Shift Arm Release Motor
5	Check the FIN Shift Arm Release Position HP Sensor [Part(s) to be checked] FIN Shift Arm Release Position HP Sensor - Floor Finisher Main Board [Confirmation details] Is the FIN Shift Arm Release Position HP Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Shift Arm Release Position HP Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 6	In case of falling off or improper installation Reassembly of the FIN Shift Arm Release Position HP Sensor If there is an abnormality (damage/wear) Replace the FIN Shift Arm Release Position HP Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
6	Check the operation of the FIN Shift Arm Release Position HP Sensor Are the following sensor operating normally in Failure Verification menu? FIN Shift Arm Release Position HP Sensor	Go to step 7	Replace the FIN Shift Arm Release Position HP Sensor
7	Replacing floor finisher main board Replaced the floor finisher main board, did the phenomenon improve?	End	Contact Epson local service representatives.