FIN Stapler Drive Motor Front Rear Error

Error code

035013 FIN Stapler Drive Motor Front Rear Error

Occurrence condition

Even if the IN FIN Stapler Carriage Drive Motor is driven in the direction of HP sensor fluctuation for 3 seconds, the change in the FIN stapler carriage HP sensor is not detected.

Assumed cause

FIN Stapler Unit dirty, falling off, or malfunctioning
FIN Stapler Unit Drive Parts dirty, falling off, or malfunctioning
FIN Stapler Carriage HP Sensor dirty, missing or defective
FIN Stapler Carriage Drive Motor dirty, missing or defective
Floor Finisher main board failure

Related parts

FIN Stapler Unit
FIN Stapler Unit Drive Parts
Stapler Carriage FIN HP Sensor
FIN Stapler Drive Motor
Floor Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Check the FIN Stapler Unit Is the FIN Stapler unit assembled correctly?	Go to step 2	If the FIN Stapler Unit cannot be moved manually, fix the part where it is stuck.
2	Check the FIN Stapler Unit Drive Parts Is the FIN Stapler Unit Drive Parts installed properly? Are there any problems with the drive parts?	Go to step 3	Reinstall the FIN Stapler Unit Drive Parts Replace if not repaired
3	Check the FIN Stapler Carriage Drive Motor [Part(s) to be checked] FIN Stapler Carriage Drive Motor - Floor Finisher Main Board [Confirmation details] Is the FIN Stapler Carriage Drive Motor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Stapler Carriage Drive Motor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 4	In case of falling off or improper installation Reassembly of the FIN Stapler Carriage Drive Motor If there is an abnormality (damage/wear) Replace FIN Stapler Carriage Drive Motor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
4	Check the operation of the FIN Stapler Carriage Drive Motor Are the following motors operating normally in Failure Verification menu? FIN Stapler Carriage Drive Motor	Go to step 5	Replace FIN Stapler Carriage Drive Motor
5	Check the FIN Stapler Carriage HP Sensor [Part(s) to be checked] FIN Stapler Carriage HP Sensor - Floor Finisher Main Board [Confirmation details] Is the FIN Stapler Carriage HP Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Stapler Carriage HP Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 6	In case of falling off or improper installation Replace the FIN Stapler Carriage HP Sensor If there is an abnormality (damage/wear) Replace the FIN Stapler Carriage HP Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
6	Check the FIN Stapler Carriage FIN HP Sensor Are the following sensor operating normally in Failure Verification menu? Stapler Carriage FIN HP Sensor	Go to step 7	Replace the FIN Stapler Carriage HP Sensor
7	Replacing floor finisher main board Replaced the floor finisher main board, did the phenomenon improve?	End	Contact Epson local service representatives.