FIN Width Adjustment Motor Rear Error

Error code

035012 FIN Width Adjustment Motor Rear Error

Occurrence condition

00114 FIN Post-Alignment jam was detected twice in a row.

Assumed cause

Deformation, dropout, or failure of FIN Alignment Plate Rear
Deformation, dropout, or failure of IFIN Alignment Plate Rear
FIN Alignment Plate Rear Motor dirty, missing or defective
FIN Post-Alignment Plate HP Sensor dirty, missing or defective
Floor Finisher main board failure

Related parts

FIN Alignment Plate Rear
FIN Alignment Plate Rear Drive Parts
FIN After Width Alignment Motor
FIN Alignment Plate Rear HP Sensor
Floor Finisher Main Board

Troubleshooting

Step	Confirmation and action	YES	NO
1	Check the FIN Alignment Plate Rear Is the FIN Alignment Plate Rear assembled correctly?	Go to step 2	If the FIN Alignment Plate Rear cannot be moved manually, fix the part where it is stuck.
2	Check the FIN Alignment Plate Rear Drive Parts Is the FIN Alignment Plate Rear Drive Parts installed properly? Are there any problems with the drive parts?	Go to step 3	Reinstall the FIN Alignment Plate Rear Drive Parts Replace if not repaired
3	Check the FIN Width Adjustment Motor Rear [Part(s) to be checked] FIN Width Adjustment Motor Rear - Inner Finisher Main Board [Confirmation details] Is the FIN Width Adjustment Motor Rear missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Width Adjustment Motor Rear? Are the connectors connected properly? Are there any problems with the wires?	Go to step 4	In case of falling off or improper installation Reassembly of the FIN Width Adjustment Motor Rear If there is an abnormality (damage/wear) Replace FIN After Width Alignment Motor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
4	Operation check of FIN After Width Alignment Motor. Are the following motors operating normally in Failure Verification menu? Width Adjustment Test (A3) Width Adjustment Test (LD)	Go to step 5	Replace FIN Width Adjustment Rear Motor.
5	Check the FIN Alignment Plate Rear HP Sensor [Part(s) to be checked] FIN Alignment Plate Rear HP Sensor - Inner Finisher Main Board [Confirmation details] Is the FIN Alignment Plate Rear HP Sensor missing or improperly installed? Is there any abnormality (damage/wear) in the FIN Alignment Plate Rear HP Sensor? Are the connectors connected properly? Are there any problems with the wires?	Go to step 6	In case of falling off or improper installation Reassembly FIN Alignment Plate Rear HP Sensor If there is an abnormality (damage/wear) Replace FIN Alignment Plate Rear HP Sensor Improper connector connection Clean the wire connector and reinsert it. If the wire is abnormal Replace the wire.
6	Operation check of FIN Alignment Plate Rear HP Sensor Are the following sensor operating normally in Failure Verification menu? FIN Alignment Plate Rear HP Sensor	Go to step 7	Replace the corresponding sensor
7	Replacing floor finisher main board Replaced the floor finisher main board, did the phenomenon improve?	End	Contact Epson local service representatives.