Belt Holder Right

  1. Remove the 4 screws and remove the right cover sub (A).
    • : 3x10DW
  2. Pull the lever to open the Right Door Unit (A).

  3. Follow the steps below to remove the connector cover (A).

    1.Release the dowel.
    2. Slide in the direction of the red arrow.
    3. Slide in the direction of the blue arrow to release the hook.

    Caution / 注意

    Do not close the Right door unit (D1) with the belt holder removed and the belt unit lowered from its normal position.
    The right door may not open. In this case, it is necessary to remove the Right door unit form the main unit.
    Assembly / 組み立て

    Insert the 3 hooks of the connector cover (A) into the positioning holes on the main unit.
  4. Remove the two cables (A) from the connectors.


    Assembly / 組み立て

    Connect the pink cable in the direction shown in the figure.
  5. Remove the one screw.
    • : 3x6D
  6. Unlock the 2 hooks on the right belt holder (A) by following the steps below.
    1. Slide the belt holder (A) in the direction of the red arrow.
    2. While sliding in the direction of the red arrow, move it in the direction of the blue arrow to release 2 hooks.
  7. Slide the belt holder right (A) forward to remove it.


    Caution / 注意

    Do not close the right door unit (D1) with the belt holder removed and the belt unit lowered from its normal position.
    The right door may not open.
    Assembly / 組み立て

    Fit the body frames plates (B) into the two grooves of the belt holder right (A).