Clutch, Paper Guide feed1

  1. Release the 2 dowels with a flathead screwdriver and remove the Front Cover (A).
  2. Remove the 2 screws and remove the Left Cover Upper (A).
    • : 3x10DW
  3. Remove one screw, and remove the front cover upper (A) in the direction of the arrow while pressing the hook.

    • : 3x10DW
  4. Slide the front decorative cover upper (A) in the direction of the arrow to remove it.
  5. Release the hook and remove the Front Decorative Cover Lower (A) in the direction of the arrow.
  6. Remove 6 screws and remove the Front Right Cover (A).

    • : 3x10DW/P
  7. Remove 1 screw and remove the Stay Plate (A).

    • : 3x8D/P
  8. Push in the torque limiter (A) and remove the pin (B).


    Caution / 注意

    Be careful not to lose the pin (B) because it is easy to drop.
  9. Remove the Torque Limiter (A).
  10. Remove the 4 screws and remove the right cover sub (A).
    • : 3x10DW
  11. Remove the two screws and slide the Left Cover Sub Upper (A) in the direction of the arrow to remove it.
    • : 3x10DW
  12. Pull out the C1 cassette (A). (about 100mm)
  13. Pull out the C2 cassette (A). (about 100mm)
  14. Remove 2 screws and remove the Left Cover Lower (A) in the direction of the arrow.

    • : 3x10DW
  15. Remove 1 screw and remove the Left Cover Sub Lower (A) in the direction of the arrow.

    • : 3x10DW
  16. Remove one screw and remove the Rear cover lower (A) in the direction of the arrow.

    • : 3x10DW
  17. Disconnect the cable (A) from the connector.
  18. Remove 2 screws and remove the  High Voltage Board Cover (A).

    • : 3x8D/P
  19. Remove 3 screws.

    • : 3x8D/P
  20. Release the 2 clamps.
  21. Disconnect the cable (A) from the connector and remove the High Voltage Power Supply Assy  (B).
  22. Disconnect the cable (A) from the connector.
  23. Remove the C ring (B) and remove the Clutch, Paper Guide feed1 (C).


    Assembly / 組み立て

    Align the concave portion of the Clutch, Paper Guide feed1 (C) with the protrusion on the main unit.