Pre-Head Paper Sensor paper feed delay error
Error code
- 53 Pre-Head Paper Sensor paper feed delay error
Occurrence condition
- The Pre-Head Paper Sensor is already ON when sensor check begins.
Assumed cause
- Foreign objects or pieces of paper in the paper transport path
- The Pre-Head Sensor has a dirty surface, has fallen off, or is faulty
- The Anti Static Brush has fallen off
- MCU board failure
Related parts
- Pre-Head Paper Sensor
- Anti Static Brush
Troubleshooting
| Step | Confirmation and action | YES | NO |
|---|---|---|---|
| 1 | Check paper transport path Is there any foreign matter, paper chips, etc. in the paper transport path? |
Remove foreign matter, paper fragments, etc. | Go to step 2 |
| 2 | Check the operation of the Pre-Head Paper Sensor Check the operation of the Pre-Head Paper Sensor with the diagnostic function. Judgment: Does the signal change between when the paper is placed and when it is not? |
Go to step 3 | Go to step 4 |
| 3 | Check the Pre-Head Paper Sensor for installation, dirt, and connector connection Is the Pre-Head Paper Sensor installed improperly? Is there dirt on the sensor? Is the connector not fully inserted? Is the paper feed connector on the front frame side not inserted halfway? |
Go to step 4 | Clean the sensor surface, or fully insert the connector. |
| 4 | Check the Anti Static Brush Unit installation Is the Anti Static Brush Unit listed in the “Assumed cause” section clean and installed properly? |
Replace the Anti Static Brush Unit |
Clean and reinstall the Anti Static Brush Unit. |