C1 Pickup Unit
 Check Point / チェックポイント |
When replacing this part, you need to run the menu from the service support mode before replacing it. |
- Open the right door unit (A).
Assembly / 組み立てWhen closing the right door unit, it may not close due to interference with the tumbler (A) that was tilted toward the front when other parts were repaired.
If the right door unit does not close, check the position of the tumbler, and if it is protruding toward the front, fit the tip of the tumbler plate (C) into the hole (B) in the main unit.
- Raise the Guide PF Inner (A) and push it in the direction of the arrow to release the dowel, then remove the Guide PF Inner.
Assembly / 組み立てPut the shaft (A) on the inward side of the lever (B) and attach it.
- Pull out the tab of the Tumbler (A) from the hole, then raise the Tumbler.
- Remove the 2 screws that secure the Guide PF Inner Lever Assy (A).
: 3x8M
- Remove the dowel, and remove the Guide PF Inner Lever Assy (A).
Assembly / 組み立てBe careful not to let the C1 Pickup Unit cable (A) get caught between components.
Before installing the Guide PF Inner Lever Assy (B), be sure to put protruding cables into the C1 Pickup Unit.
- Pinch the tab and pull it in the direction of the arrow to remove the C-ring (A).
- Remove the bearing (A).
- Remove the Tumbler (A) in the direction of the arrow.
Assembly / 組み立てAlign the pin (B) of the shaft with the groove (A) of the gear and install.
- Remove the C1 cassette (A).
- Remove the 3 screws and remove the Paper Guide Lower (A).
- : 3x8M
: 3x5D
- Release the cable from the clamp (A) and disconnect the cable from the 2 relay connectors (B).
Assembly / 組み立てAttach the cable ties (A) so that it is disposed toward the back side of the clamp (B).
- Remove the 5 screws, and remove the C1 Pickup Unit (A).
- : 3x8M
| Check Point / チェックポイント |
After replacing this part, you need to run the menu from the service support mode. (If you ran the Before-replacement menu before replacing the part, it will start automatically when you turn the power on.) |