B80 PRINT HEAD SEQ (ADJUSTMENT AFTER REPLACEMENT)

Overview

Sequentially display the adjustments required after Printhead replacement.

Caution / 注意

“Preparation Before Replacement (Printhead)” must be performed before Printhead replacement because this adjustment is designed accordingly. Make sure to perform “Adjustment After Replacement (Print head seq)” in the state that “Before Repair Operation (Printhead)” is performed before replacing the Printhead.
Work Procedure

  1. Start the printer in the service mode.

  2. Select "B80 Head Replace Seq" refer to "How to select an Adjustment item".

  3. The inspections and ink filling are executed in the following sequence.

    1. B10 HEAD ID INPUT

    2. B21 CR SCALE CHECK
    3. B26 NOZZLE NOISE CHECK
    4. Ink charge
      (C01 HEAD INK FILL/C02 INITIAL FILL (INK FILL)

    5. B32 NOZZLE CHECK PATTERN

      Caution / 注意
      • The printer selects the Ink Fill Level (Head Ink Fill or Initial Fill) automatically by state of the “Before Repair Operation (Printhead)”.
      • The case of not perform the “Before Repair Operation (Printhead)”, Ink fill necessity confirmation menu is displayed.

  4. After ink filling completes, adjustment is executed in the following order.

    1. B43 HEAD ANGULAR ADJ. MECH

    2. B44 HEAD ANGULAR ADJUSTMENT. SOFT
    3. B61 PTS Acc./ Dec. Adjust (S)
    4. B62 BI-D ADJUST (S)
    5. B63 BI-D BAND ADJUST (S)
    6. B64 BAND FEED ADJUST (S)

  5. Perform check pattern printing, check that there is no problem.