Paper Feed Roller Spring
- Lift the printer, then remove the Optional Paper Cassette (A).
Assembly / 組み立てWhen attaching the Optional Paper Cassette, be sure to align the positioning pins (A) (x2) and the dowels so as to avoid damage to the Drawer Connector (B).
- Pull the Paper Cassette 2 (A), then remove it from the Optional Paper Cassette Unit (B).
- Open the Rear Cover.
- Remove the leg of the Paper Feed Roller Spring from the Paper Feed Detection Lever.
D: Shape of the spring
Caution / 注意Since the narrow part of the Paper Feed Detector Lever (A) may be bleached and damaged, remove the Paper Feed Detector Lever (A) by ensuring that it does not get twisted.
As shown in the figure below, with the Paper Feed Detection Lever in the rotated state, remove the Paper Feed Detection Lever from the Vertical Feed Roller in the direction of the arrow.
Assembly / 組み立てWhen attaching the Paper Feed Detector Lever (A), be sure to align the flag section (B) of the Paper Feed Detector Lever (A) with the slit shown in the figure below.
- Remove the E-ring (plastic) (B) from the left side of the Vertical Feed Roller (A).
Remove the One-way Clutch Assy (A) from the Vertical Feed Roller (B).
Assembly / 組み立てWhen attaching the One-way Clutch Assy (A), make sure the arrow mark is facing outside as shown in the figure below.
- Remove the straight leg (B) of the Paper Feed Roller Spring (A) from the slit of the frame.
- Slide the Vertical Feed Roller (A) in the direction of the arrow, and remove the bearing B (B) from the hole in the frame.
- Remove bearing A (B) from the Vertical Feed Roller (A), and then remove the Vertical Feed Roller (A) from the hole in the Hopper Drive Frame.
- Pull out and remove the Paper Feed Roller Spring (B) from the Vertical Feed Roller (A).
Assembly / 組み立てWhen attaching the Paper Feed Roller Spring (A), insert the straight leg (B) of the Paper Feed Roller Spring (A) in the slit of the frame.
- C: Shape of the spring