Blank printout (blank paper ejected)

Symptom

Paper is discharged as blank.

Suspected cause

Paper (Used paper, heavy paper)
Output Setting
Network trouble
Dirt/wrong installation/wear or damage of the Pickup Roller Assy or Retard Roller
Ink system Assy failure
I/S failure (tube, pump, air release valve, ink end sensor)
Main Board Assy failure
Head FFC failure
Printhead failure

Troubleshooting

Procedure	Check and measure	Yes	No
1	Check the operation when blank pages are ejected (point: whether blank pages ejected or blank pages printed) Check whether the machine begins the print operation (CR moves right and left multiple times) or not.	Begins print operation (CR moves) Go to step 6	Does not begin print operation (CR does not move) Go to step 2
2	Check the paper Check the following points about paper status. Check whether or not using paper that is thick such as paper that has already been printed on. Check whether or not the paper size and edge guide position are appropriate.	Go to step 3	Change the standard paper. Set the edge guide of paper cassette correctly.
3	Check the settings For paper settings and the print data, check the following items. Check whether or not the paper settings of the main unit and driver are appropriate. Check whether or not blank paper parts are included in the print data.	Go to step 4	Change the paper settings.
4	Check the network If the data does not arrive for 5 or more minutes after the print command, blank paper is ejected due to a timeout error. Does the blank print occur by internal printing (Status sheet, Nozzle check pattern, etc.)?	Go to step 5	If printing wirelessly, print with a wired connection. If the symptom is continued after performing the above, contact the Epson Service Support department.
5	Check the Pickup Roller Assy/Retard Rollers Check the following point. Are the Pickup Roller Assy/Retard Rollers installed correctly? Are the Pickup Roller Assy/Retard Rollers dirty? Are the Pickup Roller Assy/Retard Rollers worn out?	Go to step 6	If the rollers are not attached appropriately, reattach them. Replace the rollers if necessary when damaged or the symptom is not resolved by cleaning the surfaces.
6	Check the nozzle check pattern Print nozzle check patterns and check whether there are nozzles missing or deflection. Nozzle check pattern print method is below. Normal menu [Setting] > [Maintenance] > [Print Head Nozzle Check] Service Support Mode 20103 Service Nozzle Check Pattern	Go to step 7	Obtain the information as follows from the service status sheet and execute head cleaning according to the nozzle missing state check matrix table. Nozzle missing rank Obtain the information of cleaning 1 to 5 from the 102 Service Status Sheet Print and execute head cleaning according to the nozzle missing state check matrix table. * If nozzle missing is not improved, refer to Nozzles missing. If nozzle missing is not improved after performing the above, go to step 7.
7	Check of Main Board Check that there is continuity of the head circuit fuses (F700 and F701) on the main board.	Go to step 8	Replace the Main Board. (Main Board )
8	Check the head FFC state Visually check the FFC terminals to make sure they are not bent up or damaged.	Go to step 9	Replace the head FFC
9	Check the Print head If the symptom is not resolved even after performing the steps above, replace the Print Head.	Replace the Printhead. (Refer to Print Head ) If the trouble is not resolved after replacing the Printhead, contact the Epson Service Support department.