VBS over-voltage error (error code: 031008)

Cause

Occurs when an abnormal voltage is applied to the head drive circuit.

Suspected cause
  • Printhead failure
  • Main Board Assy failure
  • Head FFC inserted slanted
Troubleshooting
Procedure Check and measure Yes No
1

Check the head FFC state
Check the head FFC state to make sure that the FFC is not damaged. (Head FFC connection part has come off, FFC disconnected, etc.)

Replace the following parts in sequence.

  • Print Head
  • Main Board

(If the trouble is not resolved after replacing the parts shown above, also replace the head FFC. If the trouble is still not resolved, Contact the Epson Service Support department.)

Replace the head FFC