NOZZLE DETECT CHECK [B28]

Check Point / チェックポイント

Start operation with all nozzles dispensing normally. Clean any defective nozzles beforehand.
  1. Start the service support mode. (Service mode startup and operating procedures)
  2. Select “Adjustment Main Unit: MENU” from the service support mode top menu.

  3. Select “Nozzle Rank Categories”.

    Check Point / チェックポイント

    Select and execute the corresponding adjustment item using either procedure below.

    • Selecting by entering the program number

    1. Select “Input B No.-Main Unit Adjust” from the Adjustment menu.
    2. Press the [#] button and software number key is displayed on LCD. Enter program number “28”.
    3. Press the [#] button.

    • Selecting from menu

    1. Select “Individual Adjustment: MENU” from the Adjustment menu.
    2. Select “Printing Check: MENU” from the Individual Adjustment menu.
    3. Select “Nozzle Rank Categories” from the Printing Check menu.
  4. The check result is displayed on the panel. If NG, perform head cleaning to enable the state where all nozzles discharge ink normally.