# Decompression Tube Assy

1. Open the Paper Jam Clear Cover (A).
   
2. Remove the screw on the rear side of the product, then remove the Paper Jam Clear Cover Holder (A).
   
   • : C.B.S-TITE-SCREW-3x8-F.ZN-3C
3. Disconnect the cable (B) from the connector of the Rear RIPS Cover Sensor (A).
   
4. Remove the four screws that secure the Rear RIPS Housing Assy (A).

   
   

   • : C.SHOULDER S-TITE,3X5
   • : C.B.P-TITE-SCREW-3x10-F.ZN-3C
5. Remove the Rear RIPS Housing Assy (A) pulling out the cable (C) through the hole (B) of the assy.

   
   

   Assembly / 組み立て

   Before reinstalling the Rear RIPS Housing Assy (A), remove the Paper Jam Clear Cover Sensor (B). After connecting the cable, install the sensor to the Rear RIPS Housing Assy.

6. Pull the Decompression Tube from the four Connecting Ports (A) on the Ink Supply Unit.
   
7. Pull the Decompression Tube in the Decompression Pump Unit (B) from the two Tube Joints (A).
   
8. Release the Decompression Tube from the Tube Guide in the Ink Leak Sensor Assy, and remove the Decompression Tube Assy (A).