Front Left Housing
- Remove one screw.
: C.B.S-TITE-SCREW-3x8-F.ZN-3C
- Slide the Right SC Cover (A) while pushing the dent (B) of Right SC Cover, and release the three tabs. Remove the Right SC Cover (A).
- Remove one screw.
- : C.B.S-TITE-SCREW-3x8-F.ZN-3C
- Slide the Left SC Cover (A) while pushing the dent (B) of Left SC Cover, and remove it.
- Remove one screw, and remove the Lower SC Reinforcing Plate (A).
- : C.B.S-TITE-SCREW-3x8-F.ZN-3C
- Reattach the Lower SC Reinforcing Plate (A) in its portrait orientation, then secure it with the screw.
- : C.B.S-TITE-SCREW-3x8-F.ZN-3C
- Remove the screw.
- : C.SHOULDER S-TITE,3X5
- Open the ADF/SCN Unit (A).
- Open the ADF/SCN Unit (A) and extend the support stand (B) as far as it goes, then support the ADF/SCN Unit with the support stand.
Caution / 注意Make sure that the support stand (A) is fixed with the two hooks, and the two triangle marks (B) face to each other.
Check Point / チェックポイントWhen closing the ADF/SCN Unit (A), press the switch (C) on the ADF/SCN support stand (B) and hold up the ADF/SCN Unit to disengage the two hooks, then fold the ADF/SCN support stand.
- Remove the screw.
- : C.B.S-TITE-SCREW-3x8-F.ZN-3C
- Release the Hook, then slide the Front Right Cover (A) to direction of arrows and remove it.
- Remove the five screws. (one of them is also securing the panel ground wire)
- : C.B.S-TITE-SCREW-3x8-F.ZN-3C
Assembly / 組み立てThere is a place to fasten the grounding wire (B) together when fixing the panel (A).
- Remove the two FFC clamps (A).
- Release the Panel FFC (A) and the grounding wire (B) from the guide (C).
- Open the Front Cover Assy (A).
- Slide the panel unit (A) rightward to remove it.
- Put the Panel Unit (A) at the rear side of the printer.
- Remove the seven screws, then remove the Front Housing Frame Assy (A).
- : C.B.S-TITE-R-SCREW-3x6-F.ZN-3C
- Remove the Stacker Assy (A).
- Remove the Cassette Assy (A).
- Remove the two screws, then remove the Front Left Housing (A).
- : C.B.S-TITE-SCREW-3x8-F.ZN-3C